User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 NGT transceiver compliance
- 2 Installation
- Mobile stations for NGT AR, SR, AR Voice, and VR Transceivers
- Fixed stations for NGT AR, SR, AR Voice, and VR Transceivers
- 3 The handset
- 4 Getting started
- Appendix A- Entering and editing text
- Appendix B- Using Quick Start
- Appendix C- Using a GPS receiver
- Appendix D- Transceiver specifications
- Appendix E- HF radio transmission
- Appendix F- Definitions
- Index
Installation
NGT Transceiver Getting Started Guide 17
Cables
Mounting a mobile NGT station
Most components of a mobile NGT AR, SR, AR Voice, and VR
station are provided with their own mounting cradles. For
general guidance on suitable locations for equipment and
installing these stations see the reference material on the
enclosed CD.
Mounting the handset cradle
To mount the handset cradle:
1 Mount the handset according to the fitting instructions
(Codan part number 15-00129-001) provided with the
handset cradle.
Table 2: Cables for a typical mobile NGT station
Cable Symbol Part number
CIB cable between RF unit and junction box
a
(NGT
AR and SR Transceivers only)
a. The part number for this cable corresponds to a standard 6 m CIB cable. The cable is also
available in a number of shorter and longer lengths.
08-05610-006
Handset and speaker connector cable
b
(NGT
AR Voice and VR Transceivers only)
b. The part number for the cable corresponds to a standard 6 m cable.
08-06022-001
Coaxial cable between RF unit and antenna
c
c. The part number for the cable corresponds to a standard 6 m cable. The cable is also available
in a number of shorter and longer lengths.
08-01503-006
Control cable between RF unit and antenna
c
08-05627-006
DC power supply cable
b
08-03255