CA 120 Owners Manual 128-6530 1 of 10
Your System has many features and available options some of which are selected at time of installation. Consult your installing dealer for options that may have been installed and are not listed. ARMING THE SYSTEM: 1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. 2. Press and release the LOCK button of your key chain transmitter 1 time.
PASSIVE ARMING THE SYSTEM: If the passive arming feature has been selected: Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. The dash mounted LED will begin to flash rapidly indicating that the 30 second passive arming timer has begun. If the LED does not begin to flash rapidly, then you have left a door, hood, or trunk ajar. Closing this entry point will allow the arming cycle will begin. If any entry point is opened during the 30 second arming cycle, arming will be suspended.
DISARMING THE SYSTEM: As you approach the vehicle, press and release the DISARM button on the keychain transmitter. The parking lights will flash 2 times, the siren will chirp 2 times, and the dash mounted LED will turn off. If you have the optional door lock/unlock circuit installed, the doors will unlock. NOTE: If the passive arming mode was selected at time of installation, the dash mounted LED will start flashing rapidly indicating that the system is rearming.
INTRUSION WARNING SIGNAL: This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. Upon disarm, the siren will chirp 4 times and the parking lights will flash 3 times. Enter the vehicle and before turning on the ignition switch, observe the LED flash pattern. If the LED flashes 2 times...pause, 2 times...pause etc., then an intrusion attempt was made to open the hood, trunk, or by an accessory triggering device.
MANUALLY OVERRIDING YOUR SYSTEM: USING THE VALET SWITCH/ MANUAL OVERRIDE Your system can be disarmed without the use of the keychain transmitter. This is necessary, since you will need the ability to operate your vehicle if the transmitter is lost or its battery fails. To by-pass the alarm system; 1. Open the vehicle door. The system will sound. 2. Turn the ignition key to the ON position. 3. Within 5 seconds, press and release the valet pushbutton switch.
ANTI HI-JACK MODE OPERATION 1. a) With the ignition switch on, and the doors closed, press and hold both buttons of your keychain transmitter for 1 second to initiate the anti hijack mode or open the door any time the ignition is on. b) If while the ignition is on, and a door is opened and then all doors are closed, the system will enter the anti hi-jack mode. The parking lights will turn on for 1.5 seconds to indicate the mode was initiated. 2.
CA-120 SYSTEM FUNCTIONS AT A GLANCE ALARM DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 5 FLASH...PAUSE = TRIGGER ON IGNITION SWITCH 4 FLASH...PAUSE = TRIGGER ON SHOCK SENSOR 3 FLASH...PAUSE = TRIGGER ON DOOR SWITCH 2 FLASH...
Code Systems, Inc. Limited Lifetime Warranty A Code Systems Inc. (“CODE”) vehicle comfort, convenience and security system sold to a retail consumer purchaser by an authorized dealer of CODE and installed by an authorized dealer of CODE is warranted by CODE to the original retail consumer purchaser to be free from defects in workmanship and materials for the lifetime of the vehicle in which the system was originally installed.
Code Systems, Inc. Limited Lifetime Warranty - Cont CODE shall not be held responsible for any removal and/or reinstallation charges of a defective system, damage to or theft of the vehicle or its contents, or any incidental or consequential damages caused by any failure of the system to function properly. Under no circumstances should this warranty, or system covered by it, be construed as an insurance policy against loss.
Plan duration: 3 Years from the date of installation. Plan amount: Maximum allowable value equal to insurance deductible or up to $2,500 whichever is less. Conditions of the Theft Protection Program: 1. The Theft Protection Program is non-transferable and non-assignable. 2. The system must be installed by an authorized CODE dealer. 3. Vehicle must be less than three (3) model years old at the time of installation. 4. The security system must have been fully armed at the time of the vehicle theft. 5.