Programming instructions

E. Programming the Tach Signal

Note: Skip this step if the vehicle does not have a tach wire or if this

unit will be programmed to operate without connection to the tach wire.

1. Open the vehicle hood (hood pin switch must be installed to

program tach).

2. Following the steps in Section C (Programming Selectable

Options), access Option Bank 4 / Feature 6 (page 18).

3. Start the vehicle with the key, and allow the engine to come to a

normal idle.

The unit will chirp the Siren/Horn and flash the parking lights every

three (3) seconds to indicate that it has learned the current idle speed.

4. System Power-Up and Programming, cont’d

Fuse Size & Location

Trunk

Output

Dome

Light

Parking

Lights

Door

Locks

Heater 1

Heater 2

Ignition 1/2

Main Power

15A

25A

2XUA.6dna.556

semitelbatceleS

DELsutatS

.ces5.

FFOFFO

.ces01

NOFFO

.ces02

FFONO

.nim01

NONO

Auxilary 2 Adjustment (Option Bank 4, Feature 5 & 6) Table 1.2

20A 20A 20A 5A

15A 15A 15A 20A

CA 630 install revB 8-04.pmd 8/23/2004, 9:22 AM17