Installation guide

5
LT
GREEN/BLACK FACTORY DISARM
I
PULSE BEFORE START
(-)
This wire will
supply a
( - )
200mA
pulse both upon disarming the system and
when the remote start feature is activated. Locate the factory perimeter alarm
disarm wire from the key cylinder inside the drivers door.
Verification: This wire registers ground if the key is turned to the unlock
position
in
the driver's door cylinder.
Connect the
LIGHT
GREEN/BLACK wire to the factory alarm disarm wire.
6
ORANGE
GROUND
WHEN ARMED OUTPUT
(-)
This wire
will have a continuous
(-)
200mA output when the system
is
Armed. This
wire
is
typically used for
controlling
the starter interrupt relay as well
as
window
modules or additional sensors.
This output can
be
configured
in
option programming.
8 Pin
Input Harness
1
BLUE/WHITE
INSTANT TRIGGER INPUT
(
- )
This wire is a
GROUND
input for an external sensor or secondary pin switch.
Verification: This wire when connected
will
trigger the security system.
2
GREEN
DOOR TRIGGER INPUT
(-)
Locate the vehicle's dome light or door pin switch wire.
Verification: This wire
will
register ground (NEG) when the door is opened
and the interior light is on. This wire will register positive voltage when the
door is closed and the interior light is off.
Connect the GREEN wire to the vehicle's negative door input wire(s).
NOTE: Certain vehicles may require multiple connections. Refer to vehicle
application guide.
2012
Audiovox Electronics Corporation.
All
rights reserved.
11