Installation guide

7 BROWN/RED
BRAKE
INPUT
(
+ )
Locate the vehicle's
brake light wire at the brake pedal mounted switch. This
connection is required for remote start.
Verification:
This wire registers positive voltage when the brake pedal
is
pressed.
Connect the BROWN/RED wire to the vehicle's brake light wire.
8
PURPLEJWHITE
TACH
INPUT
Locate the vehicle's ignition
coil
or
fuel injector
in
the engine compartment.
Verification:
Test using the
following procedure:
1.
Set
voltmeter to
AC
VOLTS.
2.
Attach positive
lead of a volt meter to a constant 12
volt
source.
3.
Attach negative lead of a
volt
meter to the wire to be tested.
4.
Start
the engine.
5.
Have someone press
on
the gas pedal slightly as you monitor the meter.
If
connected to the correct wire, the voltage reading will
increase as the
engine's
RPM
increases.
Connect the PURPLE/WHITE wire to the negative side of the vehicle ignition coil or
fuel injector.
2012
Audiovox
Electronics
Corporation.
All
rights
reserved.
13