Installation guide

14
1
4 P·
in
Alternate
Output
·
Har
.
ness
LT
GREEN/BLACK
FACTORY DISARM
I
PULSE BEFORE START
(-)
This wire
will supply
a ( - ) 200mA
pulse
both upon disarming the system and
when the remote start feature is activated. Locate the factory perimeter alarm
disarm wire from the key cylinder
inside the drivers door.
Verification:
This wire registers ground if the key is turned to the unlock
position
in
the driver's door
cylinder.
This output can be configured
in
option programming.
2
LTBLUE
FACTORY ARM
I
PULSE
AFTER
START
(-)
This wire
will supply a
( - ) 200mA
pulse
both upon arming the system and upon
successful completion
of the remote start activation sequence and is typically
used to
re-lock the
vehicle's doors upon remote start if necessary.
This output can be configured
in
option programming.
3
GREEN/WHITE
PULSE
AFTER SHUTDOWN
(-)
This wire will supply a ( - ) 200mA pulse
after the remote start shuts down. This
is
typically used to
re-lock
the
vehicle's
doors if they
unlock
upon remote start
shutdown.
It
can
also
be used to
pulse a door pin-switch wire to prevent the
vehicle's
accessories from remaining on after remote start shutdown.
This output can be configured
in
option programming.
4
BLACK/YELLOW
PULSE DURING
CRANK
(-)
Locate the
vehicle's
second starter (crank) wire at the ignition switch. (if
equipped)
Verification:
This wire registers
voltage only in the start (crank) position of
the ignition switch.
This output can be configured
in
option programming.
ca6553/6553sst
rev
A