Installation guide

20
Additionai
·Pons
Antenna
I
LED
I
Programming Port
Mount the supplied
antenna/receiver to
a
clear
spot
on
the vehicle's windshield
that
will not
block
the driver's vision. A good
location
is
usually high
on
the
windshield
near the rear view mirror.
Be
careful
not to mount the antenna/receiver
on
any metallic window
film,
as this will
effect system range. Route the antenna/
receiver cable
to the
control module
and
plug
into the antenna port.
Data Bus Interface Port
This 4 pin port is used for
Flashlogic
Door Lock and Transponder Databus
Interfaces
to communicate with the vehicle's
Databus. When using the
OBI
port to
control
the
Flashlogic
Door Lock and Transponder Interface modules
the
following options may
be
available. Please
refer to the
020
(Data to Data)
function
list available per vehicle
on
the tech service web site.
Tach
Input
Door Trigger
Brake Safety Shut Down
Trunk/Hatch
Open
Door Lock
Control
Passlock I
Passkey
Interface (GM
Only)
Dome Light Supervision Transponder
Interface
Activation
Factory
Alarm
Arm
I
Disarm
Diesel Glow Plug Input
Manual
Arm
I
Disarm
Inputs (factory
keyless controls
system)
Telematic Interface Port
This 4 pin port is used for
telematic Interface
accessories, such as Carlink,
which can
control
some of the following
features.
Door Lock
Control
Sliding
Doors
Car
Find
Trunk Release
AUX Output
Remote Start
ca655316553sst
rev
A