Installation guide

Set
U.p
&
Programming
Transmitter Programming - Feature
Bank
1
1.
Turn the ignition
ON.
2.
Press and
hold
the valet/override
button.
3.
Within 1 0
seconds the system will chirp (3) three times.
4.
Press 1 button of each transmitter you wish to program.
5.
The system
will
respond with 1 chirp for each accepted transmitter.
6.
Pressing the override button at anytime during programming
will advance to
the next bank.
NOTE: The system
will
exit transmitter programming after 15 seconds of inactivity.
NOTE: This system has 1 button programming which programs
all channels
of the
system.
NOTE: The system
will hold up to 4 transmitters
in
memory, programming a 5th
transmitter will
erase the
oldest
transmitter
in
memory.
NOTE: This system has PTN - Programmed Transmitter Notification. Each time the
ignition
is
turned
ON,
the LED
will flash
the number of transmitters programmed to
the system.
Transmitter
programming
for
2 Car Mode *2
way
system
only:
1.
Enter the transmitter into 2
Car
Mode. (Refer to transmitter operation
in
the
owners manual
for 2 car operation)
2.
Follow
the steps above for transmitter programming.
NOTE: 2 car mode requires
an
additional security system
installed
in
a second
vehicle.
Manual
Feature Programming - Feature Bank 2
- 5
1.
Turn the ignition
ON.
2.
Press and
hold the valet/override
button.
3.
Within 10 seconds the system will chirp (3) three times.
4.
Use the
valet/override
button to advance through each option bank. For
feature programming advance to Feature Bank
2,
3,
4 or
5,
which
is
(4)
four, (5) five, (6) six and (7) seven chirps.
5.
Use the transmitter
0
button to
scroll through the
selections
in
each
feature bank, the system
will
chirp to match the feature number.
6.
Press the transmitter
i
button to change the desired feature. The LED
will
flash indicating the changed feature.
2012
Audiovox Electronics Corporation.
All
rights
reserved.
21