Installation guide

Feature Bank 4- Remote Start Control
1 - RF Start Chirp: Turns remote start activation confirmation chirps ON or OFF.
2 - Run Time: Controls the time in minutes that the vehicle will stay running
under control of the remote start until the system times out. The system may also
be shut down at any time by use of the transmitter or system shutdowns.
3- Running Lights: Controls the WHITE parking light output wire during remote
start.
Steady - Parking lights constant during the remote start cycle.
Flashing - Parking lights flash at a slow pace during the remote start cycle.
4 - Tach Mode: Determines how the system monitors the engine running during
remote start.
Tach - Hard wired directly to the tach wire of the vehicle to monitor AC
voltage.
Tachless (Crank AverageNoltage) - Determines crank time by averaging the
last 8 times the vehicle was started with the key and then monitors the
change
in voltage after remote start.
Hybrid (Crank Average I No Voltage) -Determines crank time by averaging
the last 8 times the vehicle was started with the
key.
OBI Port - Monitors the vehicle's tach rate through an interface module
connected to the
OBI port.
5 -
Voltage Level: The voltage variance for remote start when set to tachless.
(see tach mode)
HIGH
-The variance in battery voltage from before the remote start
is activated to after the engine is running must be greater than 0.5 volts.
LOW - The variance
in battery voltage from before the remote start
is activated to after the engine is running may be less than 0.5 volts.
6 - Crank Time: Preset output times for the PURPLE starter wire.
7 -
Crank Average I Crank Time: The length of time in which the remote start
will crank the vehicle's starter.
Crank Average - Determines crank time by averaging the last 8 times the
vehicle was started with the
key.
Preset Time- Preset starter output time. (see crank time)
2012 Audiovox Electronics Corporation. All rights reserved.
31