Installation guide

4 Pin Main Harness
1
WHITE/RED
PARKING LIGHT INPUT
2
WHITE
PARKING
LIGHT OUTPUT
Locate the parking light output wire at the
vehicle's
light switch.
Verification:
This wire registers positive
voltage
when the parking
lights
are
turned on.
Positive switching Parking Lights:
Connect the
WHITE/RED
wire to a 15 Amp max fused battery source.
Connect the
WHITE wire to the parking light output wire.
Negative switching Parking Lights:
3
Connect the
WHITE/RED
wire to a good chassis ground.
Connect the
WHITE wire to the parking
light output wire.
BLACK
GROUND
Connect the BLACK wire to a solid chassis ground point using a ring
terminal
and
self tapping screw (not
supplied). Scrape
away paint from the grounding point to
ensure a good connection. The recommended grounding point is a
metal
surface
in
the driver's side kick panel
area.
NOTE:
Do not ground the BLACK wire with any other vehicle
components.
4
BROWN SIREN OUTPUT
(
+)
Locate a
suitable
mounting location in the engine compartment for the siren, away
from moving parts.
With the
bell of the siren aiming downwards, secure the siren
in
place using
self
tapping screws, being
careful
not do
drill
into any hoses, wiring or components.
Connect the BLACK siren wire to a chassis ground using a ring terminal and self
tapping screw (not
supplied).
Route the
BROWN
siren output wire from the control module through the
firewall
and connect to the RED wire on the siren.
NOTE:
Be
sure to loom the siren wires, and seal the grommet.
2012
Audiovox Electronics Corporation.
All
rights reserved.
7