Installation guide

8
6 Pin Start
Harness
1
PURPLE
STARTER OUTPUT
(
+)
Locate the
vehicle
starter wire.
Verification:
This wire registers
voltage
only
when the key
is
turned to the
START position. Cut the
vehicle's
starter wire
in
half when
installing
the
starter kill relay.
Verification after starter wire is cut:
KEY SIDE
of starter wire registers
voltage
when the key
is
turned to the
START position.
MOTOR SIDE
of starter wire registers no
voltage.
Connect
the
PURPLE
wire to the
vehicle
starter
wire,
use
the
MOTOR
SIDE
of
the vehicle
starter wire when
installing
the starter
kill
relay.
2
RED
BATTERY 12V (
+ )
Locate 1 of the
vehicle's constant 12
Volt
battery wires at the ignition switch.
Verification: This wire
will
register (
+)
voltage
in
all positions of the ignition
switch.
Connect the RED wire to the constant 12
Volt
battery wire.
NOTE: Remove
all
fuses until all connections are made.
3
ORANGE
ACCESSORY 1 (
+ )
Locate the
vehicle's
accessory wire at the ignition switch.
Verification:
This wire registers
voltage when the key
is
turned to
ACC
(Accessory) and the
ON
(or RUN) position. The voltage
drops out when the
key
is
turned to the START (or CRANK) position.
Connect the
ORANGE
wire to the
vehicle's accessory wire.
ca6553/6553sst
rev
A