Installation guide

4
PINK/WHITE
IGNITION 2 (
+)
Locate the vehicle's 2nd ignition wire at the ignition switch (if equipped).
Verification:
This wire registers
voltage
when the key is turned to the ON
(or
RUN) position,
but not the ACC
(Accessory) position. The
voltage
does not
drop out when the key is turned to the START (or CRANK) position.
Connect
the
PINK/WHITE
wire
to
the vehicle's
ignition
2
wire.
Programmable output:
IGN, ACC,
Start.
5
RED/WHITE
BATTERY 12V (
+ )
Locate 1 of the vehicle's constant 12 Volt
battery wires at the ignition switch.
Verification:
This wire
will register (
+ )
voltage
in
all
positions of the
ignition
switch.
Connect the
RED/WHITE
wire to the constant 12
Volt
battery wire.
NOTE:
Remove all
fuses
until all connections are made.
6
PINK
IGNITION
1
(
+)
Locate the vehicle's ignition wire at the ignition switch.
Verification:
This wire registers
voltage
when the key is turned to the
ON
(or
RUN) position. The
voltage
does not drop out when the key is turned to the
START (or CRANK) position.
Connect the
PINK
wire to the vehicle's Ignition
wire.
This wire is
also
used for
Ignition
1
Output.
2012
Audiovox
Electronics
Corporation.
All
rights reserved.
9