Installation guide

Feature Bank 4 - Remote Start Control

1 - RF Start Chirp: TurnsremotestartactivationconrmationchirpsONorOFF.

2 - Run Time: Controls the time in minutes that the vehicle will stay running under

control of the remote start until the system times out. The system may also be shut

down at any time by use of the transmitter or system shutdowns.

3 - Running Lights: Controls the WHITE parking light output wire during remote

start.

Steady - Parking lights constant during the remote start cycle.

  Flashing-Parkinglightsashataslowpaceduringtheremotestartcycle.

4 - Tach Mode: Determines how the system monitors the engine running during

remote start.

Tach - Hard wired directly to the tach wire of the vehicle to monitor AC

voltage.

Tachless (Crank Average/Voltage) - Determines crank time by averaging the

last 8 times the vehicle was started with the key and then monitors the

change in voltage after remote start.

Hybrid (Crank Average / No Voltage) - Determines crank time by averaging

the last 8 times the vehicle was started with the key.

DBI Port - Monitors the vehicle’s tach rate through an interface module

connected to the DBI port.

5 - Voltage Level: The voltage variance for remote start when set to tachless. (see

tach mode)

HIGH - The variance in battery voltage from before the remote start

is activated to after the engine is running must be greater than 0.5 volts.

LOW - The variance in battery voltage from before the remote start

is activated to after the engine is running may be less than 0.5 volts.

6 - Crank Time: Preset output times for the PURPLE starter wire.

7 - Crank Average / Crank Time: The length of time in which the remote start will

crank the vehicle’s starter.

Crank Average - Determines crank time by averaging the last 8 times the

vehicle was started with the key.

Preset Time - Preset starter output time. (see crank time)