Installation guide

7
BROWN/RED
BRAKE
INPUT (
+ )
Locate the vehicle's brake light wire at the brake pedal mounted switch. This
connection is required for remote start.
Verification:
This wire registers positive voltage when the brake pedal
is
pressed.
Connect the BROWN/RED wire to the vehicle's brake light wire.
8
PURPLE/WHITE
TACH
INPUT
Locate the vehicle's ignition coil or fuel injector
in
the engine compartment.
Verification:
Test using the
following
procedure:
1.
Set
voltmeter to AC VOLTS.
2.
Attach positive lead
of
a volt meter to a constant 12 volt source.
3.
Attach negative lead
of
a volt meter to the wire to be tested.
4.
Start
the engine.
5.
Have someone press on the gas pedal slightly as you monitor the meter.
If
connected to the correct wire, the voltage reading will increase as the
engine's RPM increases.
Connect the
PURPLE/WHITE
wire to the negative side
of
the vehicle ignition coil or
fuel injector.
2014 Voxx Electronics Corporation.
All
rights reserved.
13