Installation guide

Set
Up
& ·
r:-rogramrni
.
ng
Transmitter Programming - Feature Bank 1
1.
Turn
the ignition
ON.
2.
Press
and
hold the valet/override
button.
3.
Within
10
seconds the system will
chirp (3) three times.
4.
Press 1 button
of
each transmitter you wish
to
program.
5.
The system
will
respond with 1 chirp for each accepted transmitter.
6.
Pressing the override button at anytime during programming
will advance
to
the next bank.
NOTE:
The system
will
exit transmitter programming after 15 seconds of inactivity.
NOTE:
This system has 1 button programming which programs all channels
of the
system.
NOTE:
The system
will hold
up
to 4 transmitters
in
memory, programming a
5th
transmitter will
erase the
oldest
transmitter
in
memory.
NOTE:
This system has
PTN
- Programmed Transmitter Notification. Each time the
ignition
is
turned
ON,
the LED
will
flash the number of transmitters programmed
to
the
system.
Transmitter programming for 2 Car Mode *2 way system
only:
1.
Enter the transmitter into 2 Car
Mode. (Refer
to
transmitter operation
in
the
owners
manual
for 2 car operation)
2.
Follow the steps above for transmitter programming.
NOTE:
2
car mode requires
an
additional
security system installed
in
a second
vehicle.
Manual
Feature Programming - Feature Bank 2
- 5
1.
Turn
the ignition
ON.
2.
Press
and
hold
the valet/override
button.
3.
Within
10
seconds the system will
chirp (3) three times.
4.
Use the
valet/override
button to advance through each option bank. For
feature programming advance to Feature Bank
2,
3,
4 or
5,
which is
(4)
four,
(5) five, (6) six and (7) seven chirps.
5.
Use the transmitter
0
button
to
scroll
through the selections
in
each
feature
book, the system
will
chirp
to
match the feature number.
6.
Press the transmitter
i button
to
change the desired feature. The
LED
will
flash indicating the changed feature.
2014
Voxx Electronics Corporation.
All
rights reserved.
21