Installation guide
Tach Programming 
The unit 
will 
not operate 
unless 
tach is programmed or 
tachless 
option 
is 
turned ON. 
If 
an 
attempt 
is 
made 
to 
start the vehicle via the remote start without first 
programming tach, the unit 
will 
flash the parking lights 7 times indicating tach 
has 
not 
been learned and stored. 
If 
the tach rate is not properly programmed 
to 
the specific 
vehicle, the unit may not realize that the vehicle is running 
in 
certain instances 
and 
re-engage the starter motor. 
The Remote Start unit 
will 
learn the tach rate 
of 
most vehicle's single 
coil,  multiple 
coil 
packs, or single injector. 
To 
learn tach: 
1. 
Turn the ignition key to the 
ON 
position. 
2. 
Press and release the valet/override button 3 times. 
3. 
Immediately turn the ignition key 
OFF. 
4. 
Press and hold the valet/override button, then start the 
vehicle 
using 
the 
key. 
5. 
When the unit senses the tach signal, the parking lights 
will 
begin 
to 
flash. 
6. 
Allow 
the vehicle 
to 
settle to a normal idle speed. 
7. 
Release the valet/program push-button switch. The parking lights 
will 
turn 
on 
for 2 seconds and  1 long chip 
will indicate that the learned 
tach 
signal 
is 
stored and the unit has exited tach learn mode. 
NOTE: 
If 
the unit 
fails to learn tach rate due to 
an 
improper tach connection or a 
poor tach source, the parking 
lights will not flash. 
To 
correct this situation, locate and 
connect the PURPLE/WHITE wire 
to 
the proper tach signal, and then repeat the tach 
learn routine. 
Smart 
Tach 
less 
Mode 
Smart 
Tach 
less Mode 
is 
available only if a tach signal has never been learned 
to 
the 
system and when activated 
will 
automatically change the Tach  Mode feature 
in 
option 
programming to Tachless without the need to enter the feature programming mode. 
1. 
Activate the remote start. The parking lights should begin flashing 
7 
times indicating no tach signal has been learned. 
2. 
Within the 7 flash time period, press and 
hold 
the 
0  button. 
3. 
The system will 
chirp 1 time indicating the system 
is 
now 
in 
tachless 
mode. 
2014 
Voxx 
Electronics 
Corporation. 
All rights reserved. 
25 










