Installation guide
32 
8-
Gas 
I 
Diesel: 
Selects engine type and 
delay time for the starter output wire during 
remote start activation. 
Gas -
Gasoline 
engine,  no 
delay 
for the starter output wire. 
10 
Second 
Delay 
-
Diesel 
engine, delays 
the starter output wire for 1 
0 
seconds after the ignition has been powered up by the remote start. 
15 Second 
Delay 
-
Diesel 
engine, delays 
the starter output wire for 
15 
seconds after the ignition has been powered up by the remote start. 
20 
Second 
Delay-
Diesel 
engine, 
delays 
the starter output wire 
for 20 
seconds after the ignition has been powered up by the remote start. 
45 Second 
Delay-
Diesel 
engine, 
delays 
the starter output wire for 45 
seconds after the ignition has been powered up by the remote start. 
9 -
Single 
I 
Double Pulse Start: 
Switches the remote start activation between a 
single 
or double 
press from the transmitter. 
10 
- Ignition 2 Output Pnik/White: 
Programmable 
high current output. 
Ignition 
2 
-
Output 
becomes active with the same timing as the ignition 
output and does not drop out during crank. 
Accessory -
Output 
becomes active with the same timing as the accessory 
output, drops out during crank. 
Start 
I 
Crank -
Output 
becomes active with the same timing as the starter 
output wire, during crank only. 
11 
- 2 or 3 Hour Start: 
When activated, the remote start 
will 
activate and run for the 
programmed time and shut down every 2 or 3 hours. 
12-
Turbo Timer: 
When activated, the 
vehicle will 
run for the programmed time. 
OFF  1 Minute  3 Minutes  5 Minutes 
13 - Transmission Mode: 
Select 
the type 
of 
remote start activation based on the 
vehicle's 
transmission type. 
Automatic - For use with automatic transmission 
vehicles. Standard remote 
start operation. 
Manual-
For use with 
manual 
transmission 
vehicles. 
Remote start ready mode 
must be set upon exit 
of 
vehicle 
to enable remote start. 
14-
Temperature Start: 
Sets the 
threshold 
temperature for temperature start mode. 
When temperature start is activated, the remote start function 
will 
activate when the 
ambient temperature drops below 
the selected temperature. 
ca6554 
Install revA 










