Instruction manual

17
Attaching a Filter
Chapter 2 Installation and Preparations
2-2 Attaching a Filter
You can mount commercially available gel filters in the
supplied filter holder and then attach them to the camera if
you wish to use an ND filter in F65RAW-HFR mode or
wish to use a filter other than those built into the camera.
Recommended filter: Fujifilm neutral density filters
1 Place the filter template (metallic disc) on the gel filter,
then trim the filter around the edge of the filter
template.
2 Remove the ring from the filter holder, place the filter
on the ring, and then attach the holder.
3 Align the protrusion on the mounting tool with the
notch on the filter holder, then insert the holder into the
tool.
4 Align the notch on the filter mount with the protrusion
on the filter holder, insert the mounting tool onto the
filter mount, and then turn clockwise until it clicks into
place.
5 Pull the mounting tool straight off.
The mounting tool separates from the camera, and the
filter is mounted in place.
To remove the filter
1 Align the protrusion on the mounting tool with the
notch on the filter holder, then press the tool onto the
filter mount.
Press the tool until it clicks into place.
2 Rotate the mounting tool counterclockwise, then lift
the tool off the camera.
The filter holder is removed with the mounting tool.
Filter holder
Filter
Ring