Technical data

6
SAFETY NORMS
GR2_3_4_5
6 SAFETY NORMS
Strictly conform to the norms reported by the plates DE2499B (fig. 1) or
DE4236 (fig. 1a) placed next to the controls, in order to avoid possible acciden-
ts while operating the crane.
Only authorized persons are allowed to operate the crane.
The crane must be used on firm, level ground.
Check that the vehicle hand brake is on and that the wheels are chocked.
Before every operation make sure that:
- no-one is within the working area of the crane;
- the safety devices are in place and operative;
- the minimum safe working distances from power lines are observed;
- the load is correctly slung and hooked.
Stabilize the vehicle by the outrigger rams, making
sure that:
- the lateral supports are fully extended;
- the wheels are in contact with the ground and the
suspension is not completely unloaded.
Use the crane in accordance with the use and maintenance
manual, making sure that:
- the load and radius are within the maximum limits
shown on the crane capacity plate;
- the crane is used progressively avoiding sudden
load movements
- swinging or dragging of the load is avoided;
- the load is lifted before rotating.
When using implements protect the crane working area
with a barrier.
The vehicle/crane are not left unless the power take off
is disengaged and the load is on the ground.
Before driving the vehicle make sure that the outrig-
gers are fully retracted and re-entered, the safety taps
closed and the crane is in folded position.
fig. 1
HORIZONTAL VERSION
VERTICAL VERSION
fig. 1a