Technical data
What to do in case of alarm
CODE REMEDY
  01  Take off the tension to the system and take on again the tension. If the
    problem remains, take off the tension to the system again, take on the
    tension and wait 12 minutes (12 minutes waiting time is a compulsory
    condition and needs to be checked with a watch), take off the tension 
    to the system again, take on again the tension.
    If the problem remains, you must immediately go to a FASSI
  authorised Center.
  02  Check the connector of the pressure transducer.
    If the problem remains, you must immediately go to a FASSI
  authorised Center.
  04  See code 02.
  06  See code 02.
  08  Check if the red light on the proximity sensor is off and verify if
    the metallic band is rightly positioned.
  09  See code 08.
  10  Check that the connector of the mercury sensor level is not damage.
    If the problem remains, you must immediately go to a FASSI
  authorised Center.
  11  You must immediately go to a FASSI authorised Center.
  12  See code 11.
  14  See code 11.
  15  See code 11.
  16  See code 11.
  17  See code 11.
  18  See code 11.
  19  See code 11.
  20  See code 11.
  21  Replace the 10A fuse at the nearest workshop after removing 
    the carter and the cover of the main panel FX000. (See electric
    schematic Par. 5)
  22  See code 11.
  Only for crane with slew ring:
  30  See code 11.
  31  See code 11.
  32  See code 11.
  33  See code 11.
  34  See code 11.
  35  See code 11.
  36  See code 11.
  40  See code 11.
  41  See code 11.
  42  See code 11.
MESSAGES  REMEDY
"WINCH OFF" 
  Place the distributor bank lever controlling the winch in
   neutral position.
"WINCH CAL.ERROR"
  See code 11.
"STOP BOOM OUT" 
Place the distributor bank lever controlling the extension
        booms in neutral position. If the warning appears when
        the winch cable lifting stroke end is not reached, place in
        any case the lever in neutral position and then restart to
   operate.
"STOP BOOM UP"
  Lifting functions not available; are authorized only descent
   functions.
To verify the right working of the differents input it is possible to use the display 
in the "INPUT" menu.
16.7.1
CONTROLS TO
OPERATE THE CRANE
GRU FASSI










