Technical data

b. “NO LOAD” (fig. 13)

In this case the load exceeds the max lifting value of the selected manual

extension (it could still be on the ground). Unhook the load since it cannot

be lifted using the selected manual extension. As in the preceding case, if

you keep pressed the "F2" key, it is possible to have an indicative evalua-

tion of the weight applied on the hook (fig. 11).

c. “NO SPEED” (fig. 14)

The load has been lifted too quickly; the whole procedure must be repeated

from the beginning. The "LMI" key on the push-button panel or "F2" key on

the control panel is disabled because it has not been possible to calculate

the applied weight. Press INDEX on the push-button panel or "F1" key on the

control panel to exit the procedure and go back to the standard operation. Put

down the load on the ground and repeat the whole procedure from the begin-

ning.

d. “NO LOAD CRANE!” (fig. 15)

This message informs that the lifted load exceeds the max limit value of the

crane/jib, irrespective of the manual extensions, so that the load cannot be lifted

in this configuration due to the crane/jib overload. Also in this case the load must

be either removed or approached to the crane, and handled in a different way

without using the selected manual extension. Moreover the whole procedure

must be repeated from the beginning.

18.2

USE OF IMPLEMENTS

GR2_45»65_3_4_5_SE

fig. 13

fig. 14

fig. 15