User's Manual

To engage the service mode, turn the ignition key to the ON or
RUN position, depress and hold the brake pedal then, press and
release the START (key icon) button on the remote control
transmitter three (3) times. The system will pause for one second
and then flash the parking lights three (3) times indicating that the
system is in service mode. When attempting to activate the remote
start system while in service mode, the parking lights will flash
three (3) times and will not start.
To disengage the service mode, turn the ignition key to the ON
or RUN position, depress and hold the brake pedal, then press and
release the START (key icon) button on the remote control
transmitter three (3) times. The system will pause for one second
and flash the parking lights one (1) time indicating that the system
has exited service mode.
Important Note: When taking your vehicle in for service, it is
recommended that you inform the service personnel that your
vehicle is equipped with a remote start system.
Remote Transmitter Programming Mode
1. Open the driver’s door (the driver’s door must remain opened
throughout the entire process).
2. Insert the ignition key into the vehicle’s ignition cylinder and turn
to the ON or RUN position.
3. Locate the small black programming button behind the fusebox
cover on the left side of the driver’s side lower dashboard.
4. Press and hold the black programming button for 10-15 seconds.
The horn will honk and the parking lights will flash three times to
indicate that the system has entered transmitter programming
mode.
5. Press and release the START (key icon) button on each trans-
mitter. The horn will honk and the parking lights will flash one
time to indicate a successful transmitter learn each time the
START (key icon) button is pressed.
6. To exit transmitter programming mode, turn the Ignition key to
the OFF position, remove the ignition key from the ignition cyl-
linder and test operation of the remote transmitter(s).
Enabling / Disabling Confirmation Horn Honks
1. Follow steps 1-4 in “Remote Transmitter Programming Mode”
above.
2. Pressing the vehicle’s brake pedal will enable the confirmation
horn honk feature. The vehicle’s horn will honk 1 time to indicate
that confirmation horn honks have been disabled and honk 2
times to indicate that confirmation horn honks have been enabled.
3. To exit programming mode, turn the ignition key to the OFF pos-
ition, remove the ignition key from the ignition cylinder and test
operation of the remote transmitter(s).
See your owner’s manual for additional information on the remote
engine start system.