User manual

C004386_07_CR2500_ User_Manual - 13

Save Settings

Permanently Establishing a Connection

Scan the Save Settings Code at the bottom of the page to make the RF settings (including which device to connect to)

permanent on the reader:

Disconnecting from the Device

You may force disconnection by reading the disconnect code below (The CR2500 may not appear

disconnected in the slave Bluetooth connection manager for 10 – 15 seconds after the command is issued). The CR2500

will also disconnect after 90 seconds of inactivity (Note: You may change the radio sleep time out setting; however, it may

reduce battery life).

Bluetooth Disconnect

Reconnecting to the Device

If the device is saved in RF mode and has a save connection (save was performed while connected) it will automatically

reconnect when:

1. CR2500 is powered up

2. CR2500 wakes from sleep mode

3. CR2500 reads another code

1.8.2 - Bluetooth Radio Auto Connect

Auto Connect: After coming out of sleep mode or after powering up the CR2500 tries to auto connect with the last

Bluetooth radio with which it was connected if the steps (previous) were followed (see Section 1.7.1 - Connecting with a

Quick Connect Code). You may also re-connect by scanning a QuickConnect code.

Scan the following codes to enable or disable Auto Connect feature for the Bluetooth radio:

Bluetooth Radio Bluetooth Radio

Auto Connect: On (Default) Auto Connect: Off

1.8.3 - Bluetooth Radio Auto Disconnect

Auto Disconnect: This feature is used when multiple CR2500 readers are connecting to the same Bluetooth Radio. By

enabling Auto Disconnect the CR2500 radio disconnects after each data transmission, allowing other radios to connect.

Scan the following codes to enable or disable Auto Disconnect feature for the Bluetooth radio:

Bluetooth Radio Bluetooth Radio

Auto Disconnect: On Auto Disconnect: Off (Default)

Note: Auto Connect should always

be set to “On” if Auto Disconnect

is set to “On”. Otherwise the

QuickConnect code would need

to be re-scanned after every

disconnect.

1.8 - Bluetooth Radio Operation (continued)