Instructions / Assembly

ManualsBrandsCODEL DOORS ManualsDoors & Windows32 in. x 96 in 1 Panel Wood Core White Primed Smooth MDF Interior Door Slab

NEEDED MATERIALS & TOOLS

REMOVE PACKAGING & INSPECT DOOR

REMOVE PACKAGING

Remove shipping materials such as corner covers, shipping blocks or pads.

Note! Be sure to remove the shipping clips from the door before beginning the installation.

INSPECT DOOR

• Cosmetic damage

• Product squareness (diagonal measurements must be within 1/4" dierence)

• Correct product (size, color, grid pattern, handing, glazing, energy eciency requirements, etc.)

• Correct Handing. To determine door swing (left or right), face the door from the side where hinges cannot be seen.

Right handed doors open to the right, while left handed doors open to the left.

If any of the above conditions represent a concern, do not install the door.

Contact your dealer or distributor for recommendations.

MATERIALS

• 10d Finish nails

• 4d Finish nails

• Shims

• Wood putty

• Sandpaper

• Finishing materials

• 100% polyurethane sealant

(for two piece frames)

Note! Follow all material manufacturers’

instructions for proper use and compatibility.

TOOLS

• Hammer

• Tape measure

• Utility knife

• Level (4 ft. minimum recommended)

• Circular saw or jigsaw (for trimming

jambs if necessary)

• Nail punch

• Screwdrivers

INSPECT ROUGH OPENING

• Verify the width and height of the door frame are each 1/2" smaller than the

rough opening width/height.

• Verify the rough opening is square. The (A) and (B) measurements should be

the same. Maximum allowable deviation from square is 1/4".

• Verify the rough opening is level and plumb (C) and (D). The maximum

allowable deviation is 1/8".

• The rough opening sill must not be crowned or sagged (D).

• The exterior face of the rough opening must be in a single plane (E) with less

than 1/8" twist from corner to corner.

• Minimum double studs should be used at all rough openings.

• The header must be supported by trimmer studs. Do not install the door unless

the rough opening meets the above conditions. Professional assistance may be

necessary to correct problems before installation.

IMPORTANT! The door should be nished either before installation or

immediately after (whichever is more convenient).

Summary of content (2 pages)

PAGE 1
NEEDED MATERIALS & TOOLS MATERIALS • 10d Finish nails • 4d Finish nails • Shims • Wood putty • Sandpaper • Finishing materials • 100% polyurethane sealant (for two piece frames) TOOLS • Hammer • Tape measure • Utility knife • Level (4 ft. minimum recommended) • Circular saw or jigsaw (for trimming jambs if necessary) • Nail punch • Screwdrivers Note! Follow all material manufacturers’ instructions for proper use and compatibility.
PAGE 2
INSTALL DOOR Warning! To avoid injury, use at least two people to install. Adequately support the door until completely fastened. Pre-hung doors will be either a one or two piece jamb system. One piece jamb doors come without trim applied. 1. Pre-hung door frames extend below the slab to allow for different floor heights. The jambs can be trimmed as needed before beginning installation, however make sure to leave adequate space to allow air to pass under the door according to ventilation codes. 2.