Programming & Operating Instructions POI-2/4/5K-0209 CODELOCKS LLC 2930 - B College Avenue Costa Mesa CA 92626 USA CODELOCKS LTD Castle Industrial Park Kiln Road, Newbury Berkshire RG14 2EZ UNITED KINGDOM Tel +1 714 979 2900 Fax +1 714 979 2902 sales@codelocks.us Tel + 44 (0) 1635 239645 Fax + 44 (0) 1635 239644 sales@codelocks.co.uk www.codelocks.
CODES T he factory set Master Code is #1234. This should be changed immediately after installation (see program 10). T he Master Code and optional Sub-Master Code always start with the # prefix. This puts the lock into Programming Mode. hen the Master or Sub-Master Code W is entered 3 times consecutively without performing a programming function, a penalty time of 10 seconds is activated. This feature is to discourage the casual use of Master Codes as User Codes.
CODELOCKS CL4000 AND CL5000 ELECTRONIC LOCKS REMOVAL OF FRONT-LOAD CYLINDERS TO CHANGE KEY BY PASS FUNCTION, TO REPIN CYLINDERS, OR TO REPLACE WITH CYLINDERS BY A DIFFERENT MANUFACTURER * 1. Remove handle 2. Turn key 90º and cylinder cover. clockwise and remove cylinder from boss. * 3. Remove key from cylinder. Hold down the control pin in the end of the cylinder and unscrew the cap. 4. Replace the tailpiece, hold down the control pin and screw the cap fully on without tightening.
PROGRAMMING First change the factory Master Code #1234 – see program 10. If the Master or Sub Master *Code is entered 3 times consecutively without performing a programming function, a penalty time of 10 seconds is activated. Note: O n the CL2000 and CL4000 locks the at the bottom of the keypad acts as the # button. The Master Code and Sub-Master Code MUST always start with #. Codes can only be the same length as the Master Code. A or in the Key Sequence below indicates LED illumination.