COEF srl. Via Albinatico, 80-82 51019 Ponte Buggianese (PT) ITALY Sirio 1800DV / 2500DV Graphic & pagination PC CAD & VIDEO www.coef.it / www.coef.
INTRODUCTION Thank you for using the Sirio 1800DV/2500DV ! The Sirio 1800DV/2500DV projects, thanks to an extremely efficient optic system (international patent n. WO99/40361), a powerful light beam which can create numberless color shades. Its performances, in terms of luminousity and lighted surfaces, can reach incredible levels. The Sirio 1800DV/2500DV comes in two versions: • Cod. 02B012 Sirio 1800DV for MHD 1200W discharge lamp • Cod.
DANGER SIGNAL: Generic dager signal and electric shock danger signal. GENERAL WARRANTY CONDITIONS • • • • • • • • The guarantee is valid for a period of 12 months from the date of purchase of the equipment. The guarantee is not valid in case a wrong voltage or frequency is selected. The parts which are proved to have manufacturing defects are also covered by the guarantee.
INPUT CONNECTOR FOR 1800W CONNETTORE 3 POLI PER L’INGRESSO RETE ALIMENTAZIONE INPUT CONNECTOR FOR 2500W High Power BEFORE USING fig.1 WARNING: The equipment must be earthed. IP 54 grade: the equipment must be installed on the horizontal plane. Read all cautions and warnings to page 1 prior to install this equipment.
INSTALLATION OF THE DISCHARGE LAMP MSD 1200W, MSR 1800W E C A C1 G D C fig.2 In case of replacement of the lamp or maintenance, do not open the fixture unless 5 minutes have passed from the switching off. This operation has to be done when the apparatus is disconnected from the mains supply. 1) 2) 3) 4) 5) 6) Disconnect power before lamp’ s replacement. Wear gloves and goggles.
CONTROL PANEL fig.4 On the control panel of the Sirio 1800DV/2500DV (pict.4) you can find, besides the display, the leds and the buttons to use to set the spot.
SUMMARY OF THE PROGRAMMING FUNCTIONS OF THE Sirio 1800DV/2500DV About twenty seconds after the switching on, the number of the software version will be shown on the display in “X_00” format.
nChn (Number of Channel) To visualise the number of channel press ENTER. Use Down and Up buttons to change the channel and, once the required one has been selected, press and keep ENTER pressed up to when the display stops flashing (it flashes to indicate that the selected option is different from the pre-set one). It is possible to set 6 channels or 7 channels ( remote reset and remote lamp switch off ). To go back to the options without making any change, press the MENU button.
CONNECTION THE DATA LINK (DMX 512) The connection of the DMX signal to the Sirio 1800DV/2500DV must be made by using the signal input XLR 5 pin connectors which are located on the control panel of the fixture. (pict.5) The pin nomenclature of the connectors for the connection to the DMX signal is listed in the table. (pict.5a) In order to avoid any problem in the signal transmission, it is warmly suggested to use a cable for high speed data transmission (sect. 2x0.25 + gnd).
USE OF THE Sirio 1800DV/2500DV IN AUTO-MODE MASTER A short list of the games can be found in appendix “B”. Press the MENU button on the control panel up to when the option MODE (pict. 7) is shown on the display, select it by pressing ENTER and the set indication will appear (no...SL).
TROUBLESHOOTING GUIDE Before calling for technical assistance, follow the recommended procedures in this appendix to solve many problems on your fixture. CAUTION! • BEFORE YUO BEGIN: Before you perform any troubleshooting procedures read the following personnel and equipment safety precautions: 1) Refer servicing to service personnel (Q.T.
DATA LINK (DMX 512) TROUBLESHOOTING Appendix “C” - Table A2 Pag. 12 http://www.coef.it - info@coef.
MAIN BOARD CONNECTIONS U11 VIPER SWITCHING C65 U5 U6 U7 U8 U9 L6219 MOTOR DRIVER U4 MICRO SLAVE MOTOR CCSLAVEXX LED +5V LED +5V OPTO DMX U3 MICRO MASTER MOTOR CC3DRVXX U13 78M05 OPTO DMX TO DISPLAY PCB PAN IP LED 320VDC MAIN POWER INPUT TO CC250 MOT3 TO HEAD FAN MOT2 DIMMER LED +28V TO PCB CC250 D1 OFF LINE BRIDGE RECTIFIER MOT1 FOCUS TO BASE FAN VRI VARISTOR 275V (OVERVOLTAGE PROTECTION) MOT4 YELLOW U12 7805 +5V MOT5 CYAN TO LAMP BOX, CYM BOX SAFETY SWITCH D3 U10 MICRO PWM FAN CONTROLL
APPENDIX -A- APPENDIX -B- Pag. 14 THE COMPLETE LIST OF DMX VALUES THE COMPLETE LIST OF THE AVAILABLE GAMES http://www.coef.it - info@coef.
