Operating instructions

Pag. 8 http://www.coef.it - [e-mail]
nChn (Number of Channel)
To visualise the number of channel press ENTER.
Use Down and Up buttons to change the channel and, once the required one has been selected, press and keep
ENTER pressed up to when the display stops flashing (it flashes to indicate that the selected option is different from
the pre-set one). It is possible to set 6 channels or 7 channels ( remote reset and remote lamp switch off ). To go back
to the options without making any change, press the MENU button.
teSt (Autotest)
To insert the auto-test press ENTER and keep it pressed up to when the display shows the flashing message t-
on (test on). To take off the auto-test press the MENU button. To go back to the options without making any change,
press the MENU button.
FLIP (Display overturning)
The display visualisation can be standard or overturned: by pressing the ENTER button the two modes will be al
-
ternatively visible. The selected one will be immediately stored in the spot setting.
To go back to the options without making any change, press the MENU button.
rSEt (Reset)
To run the complete reset press ENTER and keep it pressed up to when the display shows the flashing message
r-on (reset on). Once the reset procedure has been completed the spot will go back to the normal setting. To go back
to the options without making any change, press the MENU button.
DRIVING THE Sirio 1800DV/2500DV WITH A DMX REMOTE CONTROLLER
Press the MENU button on the control panel up to when the option nChn is shown on the display, select it by
pressing ENTER and the set indication will appear (6 or 7 channels). If you want to activate channel 7 you must set 6
channels on the display. Pass through the numbers by pressing the buttons UP and DOWN: once you have set the
required number, store it by pressing the ENTER button and keep it pressed up to when the display stops flashing
(the flashing shows that the selected option is different from the one previously stored). To exit from the selected op
-
tion without making any change press the MENU button.
Here below is shown the complete list of the functions of the Sirio 1800DV/2500DV.
The complete list of the DMX values can be found in appendix “A”
7 CHANNELS 6 CHANNELS
CH 1= Speed CH 1= Speed
CH 2= Cyan CH 2= Cyan
CH 3= Yellow CH 3= Yellow
CH 4= Magenta CH 4= Magenta
CH 5= Dimmer CH 5= Dimmer
CH 6= Basic colors+rainbow CH 6= Basic colors+rainbow
CH 7= Reset/Lamp Off
• Select the requested DMX starting address by operating on the Addr option
• Select the requested number of channel with NChn option
• Connect the DMX signal between the fixture and the controller
• Check that the DMX led is flasing. (DMX signal present)
• If there is no signal, you must manually reset by operating on the RESET option%
6/7 CHANNELS MODE SELECTION