Operating instructions

Pag. 4 http://www.coef.it - [e-mail]
BEFORE USING
Read all cautions and warnings to page 1 prior to install this equipment. Particularly, read the following:
Before connecting the equipment to the power system:
1) Make sure that the mains voltage and frequency correspond to rated values shown on the label
(pict.1).
2) Connect the mains power cable to the electronic boards inside and if necessary (synchro-mode) the
DMX cable.
The Sirio 150 / 150DV is made for a mains voltage 230V 50 Hz; 1,1A
For a power supply of 100V-120V it is necessary to use one auto transformer with the following features:
• Output voltage 230V.
• Output current 2A.
Before any operation on the fixture
a) Disconnect power before lamp’s replacement (page 5) or servicing (service personnel).
b) Do not open the lamp cover for 300 seconds after switching off.
c) Wear gloves and goggles to re-lamping (page 5) or to work inside the unit (service personnel).
Do not install the spot close to heat sources. Do not lay the connection cable on the spot when it is warm.
The unit must be positioned at least 30 cm. from walls or other flammable surfaces and minimum 1.0 meter to
lighted objects.
External surfaces temperature:
• After 5 minutes work; Tc=75°C. • Once the thermic balance has been obtained; Tc=90°C.t
The equipment must be earthed. If this rule is not followed, the warranty
will be void. IP 66 grade: to ensure the declared IP grade choose the
correct size of the cables (from 3 to 6.5mm). All the gaskets and the glass
must be keeped in full working order.
fig.1
DMX IN - DMX OUT
POWER INPUT