Operating instructions

http://www.coef.net - [e-mail] Pag. 5
In case of replacement of the lamp or maintenance, do not open
the fixture unless 5 minutes have passed from the switching off.
1) Disconnect power before installing the lamp. Wear gloves and goggles.
2) Unscrews the four screws on the glass cover and fully open the eight dichroic and shutter blades (C and F ).
3) Unscrews the screws A and B and remove the reflector parabole (D).
4) Insert the lamp (E) into the lampholder socket. Do not touch the quarz bulb with fingers. If this happenes, clean
the bulb before use with dry cloth and alcohol. Polish with a dry cloth.
5) Screws the glass cover.
INSTALLATION OF THE LAMP
fig.2
d) Replace the lamp when the lamp life is exhausted (6000 hours) to avoid bad peformances of the fixture or that
the optic system is damaged by the lamp explosion.
e) The protection screens, the lenses, or the ultraviolet filters must be replaced if they are visibly damaged and
their effectiveness has been reduced, for example, by cracks or deep scratches.
f) The lamp must be replaced if it has been damaged or thermally deformed.
g) In case of installation of the spot to a truss, check carefully that the fixture is fixed with a chain to both truss and
unit.
DICHROIC BLADE (C)
LAMP (E)
PARABOLE (D)
SCREW (B)
SCREW (A)
SHUTTER BLADE (F)