Operating instructions

COEF srl Via Albinatico 80-82 - 51019 Ponte Buggianese ( Pistoia ) ITALY pag. 14

5-SPECIAL FUNCTIONS AND PROJECTOR ASSIGNMENT

Figure 10

On the projector’s front panel of the PERFORMANCE 200 SHOW you will find a

section dedicated to the projector setting and accessory functions.

The legend shows in a very simple way how to operate the different settings and

controls, without the need of reading a manual, but we will give you herewith a clearer

explanation of the settings procedure.

See Fig. 11. All the operations are executed by means of push-buttons C, D, E,in

dicated with SELECT and SEARCH.

By repeatedly pushing C you can select the desired function, indicated on the di

splay A.

FUNCTION 1

Gives the possibility to address the projector as a number (projector n. 1, 2, 3 etc.) considering the starting channel (setted

with function 2). To go up use push-button E and to go down use push-button D.

FUNCTION 2

Gives the possibility to address the projector to a specific DMX starting channel, according to the used controller. If needed

all the projectors can be addressed in this way but you have to make sure that in Function 1 each projector is assigned as proj

ector n. 001.

FUNCTION 3

Exchange the way of direction for the PAN channel. Display B will show Std when “Standard” or OPP when “Opposite”

FUNCTION 4

Exchange the way of direction for the TILT channel. Display B will show Std when “Standard” or OPP when “Opposite”

FUNCTION 5

It changes over the assignment of the TILT to channel 7 and PAN to channel 8 and vice-versa. Std=8 TILT, 7 PAN.

FUNCTION 6

Color change in black-out position. Std = without black-out

FUNCTION 7

Gobos change in black-out position. Std = without black-out

FUNCTION 8

It will show the lamp life. To reset the time meter to 000, push either push-button D or E.

FUNCTION 9

It will show the projector ‘s working hours.

FUNCTION t

A test is executed for each projector’s channel indicated on display B.

FUNCTION d

Gives the possibility to have the display on or off. You choose to have the display off than the display will remain alight only

for 2 minutes in order to allow you the different setting. Press one push botton ( C,DorE) to have the display on again.

FUNCTION h

Set the projector for a configuration at 6 or 8 channels.

ATTENTION! Set theprojector by the FUNZION h related to the control unit.

Example: as regards MASTERSHOW 512 set the projector at 8 channels.