Operating instructions

Pag. 12 http://www.coef.it - [e-mail]
8.0 LAMP ADJUSTMENT
Open the cover of MP700 Zoom by the 4 fast screw.
The gobo-wheel of the MP 700 Zoom contains di-
chroic gobos. They are interchangeable simply by remo-
ving the little elastic ring with a screwdriver (see figure).
In order to replace a dichroic gobo with a steel gobo,
put a thick ring between the gobo and the elastic ring.
Insert the chosen gobo and place again the steel
ring, paying attention that it reaches its correct position.
9.0 GOBOS REPLACEMENT
•
Don’t look directly the beam trough the lens.
•
The lamp is pre-regulated by the factory.
Only fine-adjustment. Don’t move the screws
”C” up to upper or lower extremities.
Lamp adjustment is necessary to obtain a uniform and powerful
light beam. Switch on the projector and set the channels without
gobo and colors. Adjust the three screws C until you reach the
ideal condition between power and homogeneity.
WARNING: switch off the projector before operating