Operating instructions

http://www.coef.net - [e-mail] Pag. 5
3.0 INSTALLATION
The constructor is not be considered responsible in case of:
•
Improper use fo the unit or use by not trained staff
•
Use in contrast with the directions on work safety
•
Wrong installation
•
Defective power supply
•
Serious lacks in the necessary maintenance
•
Unauthorized modifications and interventions
•
Use of spare parts that are not original or not specific for the unit
•
Total or partial inobservance of instructions
•
Unusual events
3.1 LAMP MOUNTING OR REPLACING
•
Switch off the projector before operating.
•
The lamp used in the fixture is a high pressure lamp and must be handled very carefully.
•
The unit is realized to use only MSR700 lamp; absolutely don’t use other types of lamp.
•
The lamp must be changed if damaged or deformed by heat.
•
Wait at least 15 minutes after the projector has been switched off before operating again, in order to let it cool down
and avoid the lamp explosion.
•
Wear protection gloves and glasses.
•
Read carefully the lamp builder’s instructions.
•
Don’t look directly the lamp.
Wait 30 minutes in order to avoid burns.
Unscrew with a cross screwdriver the first screw A for a single turn; unscrew the second one completely B;
unscrew completely the screw A and to remove the cover that supports the lampholder.
Insert delicately the lamp in the projector support, driving it with the round cover.
Pay attention: the lampholder’s wires must correctly reenter in the projector. Block the cover screwing the screws
up ( part. A-B).
WARNING: read carefully