Operation Manual

Commissioning and making basic settings

1. Place the device on a level, ﬁ rm and heat-resistant surface.

2. Connect the device to a mains socket that has been properly installed.

3. The preset time "00:00" will ﬂ ash on the display.

4. Set the time using the STD (hours) and MIN (minutes) buttons.

5. Then press the PROG button to conﬁ rm your entry. The display will then stop ﬂ ashing.

Brewing coffee

1. Use the thermal cups which are supplied with the product to ﬁ ll the device, as this will

help to ensure you do not overﬁ ll the water reservoir.

2. Unscrew the lid of the thermal cup and ﬁ ll the thermal cup with tap water at room

temperature.

3. Open the water reservoir cover and ﬁ ll the water reservoir.

4. Screw the lid back onto the thermal cup. Open the drinking

cap and place the cup beneath the coffee discharge open-

ing. It is essential for the drinking cap to be open in order to

open the non-drip valve. If the drinking cap is not open, the

water cannot ﬂ ow out of the ﬁ lter compartment and in the

worst-case scenario it will overﬂ ow!

5. Open the ﬁ lter compartment and insert the ﬁ lter insert.

Make sure that you place the ﬁ lter insert into the ﬁ lter

compartment correctly. The spring for opening the non-drip

valve must be pointing in the direction of the water

reservoir.

6. Place the permanent ﬁ lter into the ﬁ lter insert and ﬁ ll it with the necessary amount of

coffee powder.

7. Make sure that the handle of the ﬁ lter insert and of the permanent ﬁ lter is folded down

so that the ﬁ lter compartment cover can close correctly.

8. Then close the water reservoir cover.

9. Press the Start/Stop button twice to switch on the device and start the brewing

procedure. The device is switched on when the red Start/Stop control lamp is lit up

and the word "ON" appears on the display.

10. When the brewing procedure comes to an end, the Start/Stop control lamp goes out

and a cup symbol on the display indicates to you that your coffee is ready to drink. If you

wish to stop the brewing procedure before it ends automatically, simply press the

Start/Stop button. The brewing procedure will be interrupted directly.

01132_DE-GB-FR-NL_V2.indb 1801132_DE-GB-FR-NL_V2.indb 18 18.03.11 13:2518.03.11 13:25