User Manual

•
•
•
•
•
•
Turning on the BlueCheck Capture Device
Getting Started - Cogent Systems, Inc. Proprietary Information 19
Turning on the BlueCheck Capture Device
To turn on the BlueCheck capture device, hold down the On/Off button
until the BlueCheck device turns on. The Power Indicator will turn red,
and the LIVE CAPTURE message will be displayed on the Display Panel .
In addition, the Bluetooth Connection Indicator will turn solid blue
when the device has connected to MobileID . You will not be able to send
any captured fingerprint images to MobileID until the Bluetooth
Connection Indicator has turned solid blue. For more information about
connecting your device to MobileID via Bluetooth , contact your System
Administrator.
Note: If the BlueCheck device is turned on before launching the MobileID
application, it may take up to 20 seconds to establish a Bluetooth
connection after the application is started.
Calibrating the BlueCheck Capture Device
If the BlueCheck capture device requires calibration (e.g., it is being
used for the first time), follow these steps:
1 Ensure that the BlueCheck capture device is turned on. For instructions
on turning on the
BlueCheck capture device, please refer the previous
section.
2 Press the
Blue button (located above NEXT on the Display Panel). The
message
CALIBRATE will be displayed on the Display Panel.
Note: If desired, you may exit from the calibration procedure at this point by
pressing the Blue button (located above NEXT on the Display Panel ).
3 Press the Green button (located above OK on the Display Panel). The
message
Calibrating... will be displayed on the Display Panel. After
approximately 5-10 seconds, the
Success message will be displayed
momentarily on the
Display Panel. The CALIBRATE message will be
redisplayed on the
Display Panel, and the calibration procedure will be
complete.