User's Manual

209 Fair Oaks Avenue South Pasadena, CA 91030 tel: [phone] fax: [phone]
yellow LED is on and green LED flash.
f, the device will be in delete work mode if present Admin card in the front of the device again,
and keeping enroll the new card if present another blank card.
2.2.3 Matching fingerprint: in verify work mode match the fingerprint with minutia in the card, the
yellow LED of device will flash and the device request the card.
a, Present the card of user near to the front of the device, the yellow LED will flash slower
than a while ago if the card had been read successfully by the device. (card can remove
away from the front now)
b, Place the finger on the sensor for 1 second, the device will beep when it captures the image
of the fingerprint.
c, Matching is completed and granted when the device beep twice and green LED flash.
Matching is denied if the device beep once and red LED flash.
2.2.4 Delete fingerprint: in delete work mode to delete fingerprint only. The red LED is on and
yellow LED flash.
a, Present the card you wish to delete in the front of the device then the device will remove the
minutia from card.
b, completed after the green LED of device flash for four times. Failed when the device beep
once and red LED flash for four times.
P.S. The status of LED: Yellow LED is meaning for “ waiting for card or finger” , green LED is
meaning for successfully, red LED is meaning failed to do something.
2.2.5 Image transferring through the network while in verify work mode:
a, Run Cogent-ServerBG.exe (Picture 2)
Picture 2