Printer User Manual

105-169-03

save your setting, then press Calibrate to perform the calibration. The

printer will respond with a ‘Successful’ or ‘Unsuccessful’ status message.

Method 2: Calibrate by Performing a Self Test; See Chapter 2

of this User’s Guide

When the Self Test has finished printing the printers default settings, the

text ‘Press Feed Switch Now to Calibrate Index’ will appear on the media.

Press the Feed switch at this time to perform the calibration.

Once completed, the Printer must be power cycled to return to its proper

printing state.

If calibration was successful, pressing the Feed button will eject only one

label at a time.

Method 3: Calibrate Using Cognitive Programming Language (CPL)

Use the Administrator’s CPL Editor tab (see below) to send the following

commands to the printer.

! 0 0 0 0

VARIABLE INDEX ON

VARIABLE FEED_TYPE GAP

VARIABLE INDEX SETTING CALIBRATE

VARIABLE WRITE

END

Notice the keyword GAP in the third line. This may be replaced by the

keywords BAR or Notch as you need.