Printer User Manual

105-169-03

Type in the following commands to a text editor on the computer:

! 0 0 0 0 (Must use zero; space between each character)

VARIABLE ETHERNET IP xxx,xxx,xxx,xxx

VARIABLE NETMASK xxx,xxx,xxx,xxx

VARIABLE GATEWAY xxx,xxx,xxx,xxx

VARIABLE WRITE

VARIABLE ETHERNET RESET

END

Send this file to the printer by selecting File then selecting Print. The

printer will not print anything but the ready light will blink on and off. Once

a solid Green ready light is visible, cycle the power to the printer. To verify

the settings have taken effect, perform a self test and verify the settings are

now set in the printer. For more instructions on performing a self test, please

refer to Chapter 2 of this User’s Guide.

SERIAL COMMUNICATION

If a serial port will be used for printing to the C Series printer, a custom

Cognitive null-modem serial cable is required. Refer to the accessories section

listed in Chapter 10 of this document or the Printer Product Guide included

on the Companion CD for ordering information.

The default serial communications settings are: 9600, N, 8, 1.

PARALLEL COMMUNICATION

If a parallel port will be used for printing to the C Series printer, a custom

Cognitive uni-directional cable is required. Refer to the accessories section

listed in Chapter 10 of this document or the Printer Product Guide included

on the Companion CD for ordering information.

When printing in parallel the port must be set up as an LPT port, not an ECP

port. If the port is configured as ECP, printing may be inconsistent.