User guide

26
Chapter 3: Setting up the Printer
B780 Two-Color Thermal/Impact Hybrid Printer: User Guide B780 UG00001 B 10/06
Enable or disable receipt test mode
The receipt test mode veries proper receipt printing. Receipt test is enabled and disabled by selecting the “Diagnostic
Modes” sub-menu of the conguration menu. See “Conguring the printer” on page 26 for instructions on how to enter
the conguration menu.
To exit the Receipt test mode:
Enter the conguration menu again. See
“Conguring the printer” on page 26
Disable the receipt test mode.
Exit the conguration menu.
The printer is on-line and can again communicate
normally with the host computer.
1.
2.
3.
4.
To run the Receipt test mode:
Enable the receipt test mode in the conguration
menu.
Exit the conguration menu.
Push the paper feed button. The receipt station
prints two code pages and cuts the receipt.
To repeat this test, push the paper feed button
again.
1.
2.
3.
4.
Enable or disable slip test mode
The slip test mode veries proper printing on a slip. Slip test is enabled or disabled by selecting the “Diagnostic Modes”
sub-menu of the conguration menu. See “Conguring the printer” on page 26 for instructions on how to enter the
conguration menu.
To run the slip test mode:
Enable the slip test mode in the conguration menu.
Exit the conguration menu.
Insert a slip into the slip station.
Push the paper feed button. Two code pages will be
printed.
To repeat this test, preform steps 3 and 4 again.
1.
2.
3.
4.
5.
To exit the slip test mode:
Enter the conguration menu again. See
“Conguring the printer” on page 26.
Disable the slip test mode.
Exit the conguration menu.
The printer is on-line and can again communicate
normally with the host computer.
1.
2.
3.
4.
Enable or disable Magnetic Ink Character Recognition (MICR) test mode
In the MICR test mode the MICR reads the characters on a check, but instead of transmitting the values to the software
it prints them out.
You can enable or disable MICR test is enabled or disabled by selecting the “Diagnostic Modes” sub-menu of the
conguration menu. See “Conguring the printer” on page 26 for instructions on how to enter the conguration
menu.
To run the MICR test mode:
Enable the MICR test mode through the
conguration
menu. Then exit the conguration menu.
Insert a check into the slip station. See “Verifying
and validating checks” on pages 35-36..
After the printer detects the check, the platen closes
and the characters are read by the MICR check
reader. The decoded data is printed as characters on
receipt paper. The platen then opens, and the test is
re-started.
The printed characters should match the characters
on the check. If the MICR check reader misreads a
character, it will print a question mark (“?”). If the
reader can’t read any of the characters, “NO MICR
CHARACTERS” appears.
1.
2.
3.
4.
To exit the MICR test mode:
Enter the conguration menu again.
Disable the MICR test mode.
Exit the conguration menu.
The printer returns to normal mode and can again
communicate with the host computer.
1.
2.
3.
4.