Specifications

CHAPTER 14
WIDTH CHANGE PROCEDURE
44
Figure 33: Bead Roller Alignment
8. If you require beads in the panel, determine the spacing needed. For Example:
a 12” wide panel with 2 beads centered on the panel would give you 3 equal
spaces or 12” divided by 3 equals 4” from center to center of each bead. Hook
the end of you tape measure on the outside bottom corner of the female leg.
Use a magic marker or grease pencil to mark the 4” and 8” locations on the
panel. You now have 3 equal spaces.
9. Loosen the slide lock bolts on the top and bottom bead assemblies (Figure 34)
and slide each bottom and top roll assembly left or right to center them on the
4” and 8” marks on the panel.
10. Lock the two top bead assemblies in the correct position by tightening the
slide lock bolt “D” on each assembly. Next align the bottom bead rollers to
the tops so that the ends of the top and bottom rollers are flush with each other
and tighten the bottom slide lock bolts on these 2 assemblies.