Specifications

CHAPTER 14

WIDTH CHANGE PROCEDURE

29. Make sure that one of the points of the top shear blade is inboard of the

vertical portion of the male leg. This part of the leg should be cut with the

angle or rake of the blade to cut in a scissor action against the vertical die. See

TOP SHEAR BLADE ADJUSTMENT (Figure 19 & Figure 20) if

adjustment is necessary.

30. Start the machine and press the shear down button to cut off the panel, then

jog the material through the shear again and stop.

31. Inspect the two cuts and adjust the dies as necessary until an acceptable cut is

made. Again, TURN THE MACHINE OFF BEFORE MAKING ANY

ADJUSTMENTS.

32. Once you are satisfied with the cut being made, you are ready to run panel.