Specifications

CHAPTER 15

PROFILE CHANGEOVER PROCEDURE

CAUTION: Always make sure your machine is shut down prior to making any

adjustments. DO NOT reach through the opening of the shear while the

machine is running. EVER! To do so could result in serious injury.

1. Remove Top Covers number 1, 2, 3, 4, and 5 (Figure 37) and set aside.

Figure 37: Remove Top Covers

2. Using a ½” wrench, remove the bolts holding the right and left Tooling Rails to

the Fixed Rail Mounts (Figure 38). Store the tooling and set the hardware near the

machine for use when installing the next profile. Note: the SS100, SS150,

SS450/450SL, and BP profiles all share the same left-side rollers, so if you are

changing from one of these profiles to another you will only need to remove the

right-side Tooling Rails. Likewise, the FF100 and FF150 profiles also share the

same left-side rollers, so if you are changing between these two profiles you will

only need to remove the right-side Tooling Rails.