Specifications

CHAPTER 17

RUN OUT TABLES AND REMOTE LIMIT SWITCH

The Run-Out Table (Figure 80 & Figure 81) attaches to the Exit End of the Shear

assembly, and is used to support the panel as it exits the machine. It is available in 10 ft.

long sections that fasten together, and have adjustable legs so they can be set to the

correct height. The Remote Limit Switch (Figure 7 on page 14) is designed to be used

with the run out tables for controlling panel length.

1. Set the first Run-Out Table on its side and in front of the machine with the leg

assembly away from the shear.

2. Open the leg assembly and set it upright on the ground.

3. Lift the attachment end of the table and drop it over the 2 threaded bolts on the

Shear Run-Out Table Bracket.

4. Loosen the 2 knob-handles on the leg assembly and allow the legs to fall free. Sight

the height of the table on the left and right side adjusting it level to the machine

using the knob-handles to lock the legs in place. See Figure 81 for correct and

incorrect set up and details.

5. Repeat the above procedures for each succeeding table and attach it to the bracket

on the end of the previous table.