Instructions / Assembly

English - 6
Installing 1 lb. Propane Cylinder
• NEVER store a spare L.P. gas supply cylinder under the
grill body or inside the grill enclosure or in the vicinity of
any heat producing appliance.
Failure to follow this information exactly could result in an
explosion and/or re causing death or serious injury.
DANGER
Only cylinders marked “Propane” must be used.
WARNING
This procedure MUST be performed OUTDOORS only!
Read and follow the directions on the cylinder.
WARNING
Tighten by hand only. DO NOT use tools.
CAUTION
■ Remove plastic cap from
top of propane cylinder
and screw cylinder into
regulator hand tight.
(Fig. 17)
■ Before attaching propane
cylinder make sure
regulator valve is closed.
(Fig. 16)
Fig. 14 Fig. 15
Pull
Pull
NOTE: Your 9962 Series grill is set up from the factory to
use a 1 lb. disposable propane cylinder.
Set up the Grill
■ Rotate counterclockwise the leg locker to release. (Fig. 11)
Fig. 12
■ Once handle is locked
in position, the grill
can easily be moved
to any location in your
campsite or backyard
by grasping the towing
handle. (Fig. 10)
Fig. 13
Fig. 10
Fig. 11
■ Slide leg extensions
into locking brackets
as shown (Fig. 13).
Bracket
Leg Extension
Install the Grease Cup
■ Pull apart the grease cup holder and insert it into drip
hole on bottom center of grill base. (Fig. 14)
■ Squeeze the grease cup holder toward center and attach
the grease cup. (Fig. 15)
■ Open up the grill from the folded position. Place one foot
on the towing handle, grasp the handle on side table,
and lift up towards you. Continue to pull up until the grill
stand is fully extended. (Fig. 12)
Fig. 17
Fig. 16