Instructions / Assembly
English - 7
If you detect a leak:
1. Stop a leak by tightening the loose joint, or by replacing
the faulty part with a replacement part recommended
by Coleman. DO NOT attempt to repair the cylinder
if it should become damaged; the cylinder MUST be
replaced.
2. If you are unable to stop a leak, remove the cylinder from
the grill. DO NOT use the grill until the leak is corrected.
How to Check for Leaks
Fixing A Fuel Leak
When to test for leaks:
1. Perform a leak test each time the gas supply cylinder is
connected to the regulator. Leak test anytime a part of
the gas system is replaced.
Leak Testing - Disposable LP Gas
Cylinders
To Prevent Fire or Explosion Hazard:
• NO SMOKING. DO NOT use or permit sources of
ignition in the area while doing a leak test.
• Perform leak tests outdoors only.
• NEVER perform a leak test with fire or flame.
DANGER
Burner and Orifice
■ Check and clean the burner/venturi tubes for insects and
insect nests. A clogged tube can lead to a re beneath the
appliance. (see the section titled “Cleaning the Venturi”)
1. Make a soapy solution of equal parts mild liquid
dishwashing detergent and water.
2. Turn off the regulator valve.
3. Apply a soap solution to the connections indicated with
the arrows. (Fig. 19) If bubbles appear at these areas, a
leak is indicated.
No Smoking
No Flame
Fig. 19
■ Proper location of the burner with respect to the orice is
important. To verify the proper installation of the burner
tube, remove the grate. The burner tube must be located
over the orice tting. See Fig. 18 (control panel not
shown).
Fig. 18
Burner
Burner Tube
Orifice Fitting