Co., Inc. Hot water Dispenser Instructions 2300-511

ManualsBrandsColeman ManualsWater Dispenser2300-511

The Water Hose Adapter connects a

standard water hose to

Hot Water on Demand

. Once adapter

is in place and water is turned on at the

source, use Hot Water on Demand

to turn water on & off and to select

desired water temperature.

WATER HOSE

ADAPTER

Instructions for Use

Model 2300-511

Summary of content (4 pages)

PAGE 1
WATER HOSE ADAPTER Instructions for Use Model 2300-511 The Water Hose Adapter connects a standard water hose to Hot Water on DemandTM. Once adapter is in place and water is turned on at the source, use Hot Water on DemandTM to turn water on & off and to select desired water temperature.
PAGE 2
Be sure Hot Water on Demand TM is turned off and no water is running through unit. Operate unit from a camp table or picnic table. Do not set it on ground to use. (Water will drain when unit is off, preventing damage in freezing temperatures. WATER HOSE ADAPTER Parts Identifier Adapter Water Inlet Fitting Water Tubing Attach Water Hose Adapter to Hot Water on DemandTM: 1. Remove water pump assembly: a. Disconnect water pump electrical connection from Hot Water on DemandTM (fig. 1). b.
PAGE 3
Attach Water Hose Adapter to Hot Water on Demand (continued): To Start Hot Water on Demand TM (continued) : TM 2. Connect Water Hose Adapter to Hot Water on DemandTM: a. Connect Water Hose Adapter electrical connection to Hot Water on Demand TM. b. Connect Water Hose Adapter to Hot Water on Demand TM by inserting Quick Connector. c. Connect and tighten water hose to adapter water inlet fitting. d. Connect water hose to water source. To Start Hot Water on Demand TM: 1. Turn on water at source (fig.
PAGE 4
Maintenance: To Clean: 1. In a clean container mix one-gallon of water with 6 oz. of a calcium, lime, and rust remover solution (available at hardware, general merchandise and food stores). 2. Disconnect water hose adapter from unit. 3. Unscrew water tubing from adapter body. 4. Detach clips from water tubing. 5. Submerge water tubing in cleaning solution. Allow to set five (5) minutes. 6. Run clean water through water tubing. 7. Air dry. 8.