Owner`s manual

within 3 seconds.
You should now see the “PROGRAM”, “FIL-
TER 1”, and “START TIME” icons on the LCD dis-
play window. The hour digit(s) will be flashing on
the LCD window. Press the “Warm” or “Cool” but-
ton to advance the hours up or down to choose the
Filter 1 start hour. Enter the hour by pressing the
“Mode/Prog” button. The minute digits will now be
flashing on the LCD window. Press the “Warm” or
“Cool” button to advance the minutes up or down,
in 5 minute increments, to choose the Filter 1 start
time. Enter the minutes by pressing the
“Mode/Prog” button.
You should now see the “PROGRAM”, “FIL-
TER 1”, and “END TIME” icons on the LCD dis-
play window. Adjust the hours and minutes for the
end time of the first filter cycle as described above.
After pressing the “Mode/Prog” button to enter
the end time of the first filter cycle, you should now
see the “PROGRAM”, “FILTER 2”, and “START
TIME” icons on the LCD display window. Adjust
the hours and minutes for the start time of the sec-
ond filter cycle as described above.
After pressing the “Mode/Prog” button to enter
the start time of the second filter cycle, you should
now see the “PROGRAM”, “FILTER 2”, and “END
TIME” icons on the LCD display window. Adjust
the hours and minutes for the start time of the sec-
ond filter cycle as described above.
After pressing the “Mode/Prog” button to enter
the end time of the second filter cycle, the new fil-
tration times will be saved into the system and the
LCD window will revert back to display the current
water temperature.
Pressing the “Time” button at any time during
the above programming sequence will save the val-
ues entered up to that point and exit the program-
ming sequence.
T
o set the spa for continuous filtration, set the
start and end times of the first filter cycle to the
exact same time
.
Clean Up Cycle
After periods of heavy use, turn the jets on to Low
Whirlpool for a four-hour clean up cycle.
Inversion Feature
The 460 Series Control includes an Inversion fea-
ture that makes it easy to read the LCD from inside or
outside the spa. To invert the LCD display, touch the
WARM or COOL button, followed by the “Blower”
button. Repeat the sequence to reverse the inversion
process.
Turbo Air Booster Option
Your spa may be optionally equipped with a Turbo
Air system to increase the performance and therapeu-
tic action of the jets. To turn the Turbo Air system on
and off, touch the BLOWER button.
Note: The Turbo Air blower will shut off automati-
cally after 15 minutes.
Note: At the start of a filtration cycle, the blower is
activated to purge the lines and ensure complete fil-
tration. Ensure that at least one air control is fully
open.
15