Manual

Place one of the blades on the hub socket and insert one of the M6-20 socket head
cap screws.
Place a plastic disk on the end of the screw and then place a self-locking nut (M6) and tighten it
with the 5mm hex key. Repeat this procedure on all three blades.















CAUTION:OVER- T ORQUEOFSCREWSCANDAMAGETHEBLADESANDWIND
TURBINE
Remove the M16 nut from the rotor shaft. Slide the blades assembly onto the rotor
shaft and
place the nut on the shaft. DO NOT press the rotor shaft into the body.
Insert the 8mm hex key into the rotor shaft and thread the nut by spinning the
blade assembly.
Hold the blade assembly and tighten the M16 nut lightly with the 8mm hex key. Finally, spin the
blades slowly to be sure they turn freely.

