Manual
















CAUTION:D ONOTOVERSCREWTHEM16NUTTHISWILLPREVENTTHETURBINE
FROMSPINNINGFREELY
Place the nose cone over the center line of the blades assembly and snap the nose
cone into
place.
Run all wires close to the batteries. Connect the Stop Switch referring to the diagram in your
manual.
CAUTION:DONOTCONNECTTOTHEB ATTERIESATTHISPOINT!
ENSURE YOUR TURBINE IS CORRECTLY GROUNDED.
Carefully raise the tower and secure base and/or guy cables.
Make sure the Stop Switch is in the off position, then connect wires to the batteries (Red wire to
Positive, Black wire to Negative).
Turn on the Stop Switch, you will see the red LED slowly blink four times to indicate that the
controller is running properly.
CONGRATULATIONS!YOUHAVECOMPLETEDYOURWINDTURBINEINSTALLATION