Manual

Congratulations on your Sunforce Products Purchase. This product is designed to the highest
technical specifications and standards. It will supply years of maintenance free use. Please
read these instructions thoroughly prior to installation, then store in a safe place for future
reference. If at any time you are unclear about this product, or require further assistance
please do not hesitate to contact our trained professionals operating the customer support line
1888-478-6435 or email to [e-mail]
ACCESSORIES INCLUDED
StopSwitch:50ampDCstopswitch. This is used to safely apply a brake to your turbine, during
either periods of intense wind or general maintenance
PlasticDisks:Antistaticplasticcomponents,thatwillprolongthelifespanoftheturbine
protectingfromweathercorrosionandstaticbuildup.
Your Sunforce Wind Turbine is designed with your personal safety as the first priority.
However, there are still some inherent dangers involved with any electrical and/or mechanical
equipment.
Safety must be the primary concern as you plan the location, installation and operation of the
turbine. Please read the following:
Important Safety Instructions
Please take the time to read through this manual prior to assembly.
1) Place this instruction manual in a safe place for reference.
2) Wait until a calm day to install or perform maintenance on your Turbine.
3) Listen to your Turbine should you hear any mechanical noise, maintenance may be
required, please contact Sunforce Products Customer Service.
4) After installation re-adjust and tighten the screws and bolts.
5) Adhere to proper grounding techniques as established by the NEC.
6) Your Sunforce Wind Turbine must be installed in accordance with this manual and local
and national building code. Incorrect installation may void your warranty.
7) Wind turbine blades spin at a potentially dangerous speed. Installation instructions must
therefore be followed carefully and respected. Never approach a turbine in motion.
Mechanical Hazard
Rotating blades present the most serious mechanical hazard. The rotor blades are made of
very strong thermoplastic. At the tip, the blades may be moving at velocities over 15m/s. At this
speed, the tip of a blade is nearly invisible and can cause serious injury. Under no
circumstances should you install the turbine where a person could come in contact with moving
rotor blades.
Electrical Hazard
The Sunforce Wind Turbine is equipped with sophisticated electronics designed to provide
protection from electrical dangers. Please note that the inherent personal dangers from
electrical current still exist, therefore caution should always be used when connecting this and
other electrical devices.
Heat in a wiring system is often a result of too much current flowing through an undersized wire
or through a bad connection.