Manual

Connect the Wind Generator to the wires and insulate the connections using either
heat shrink
tubing crimp connects or a high quality electrical tape.
The included rubber gasket helps prevent the bottom of the yaw from contacting the
top of the
pole. This rubber gasket will assist in reducing the transmission of noise down the tower.
Firmly tighten the yaw clamp screws with the 4mm hex key. Be sure that it is securely attached
to the mounts.
Slide the yaw shaft all the way down over the end of the tower being careful not to pinch
the yaw wires. Be sure to leave enough slack in the wires so that if necessary, the Wind
Generator can be removed.
Mark both ends of all the wires with tape to identify which is negative, positive and
ground
Wire Color Codes:
RED = Positive
BLACK = Negative